What would cause trailer lights not to work?

Click to rate this post!
[Total: 0 Average: 0]

A bad or missing trailer ground is a VERY COMMON reason that lights don’t work on a trailer, or they only work sometimes. A pin on the truck socket and a pin on the trailer plug are dedicated for this ground connection, so test that connection FIRST when troubleshooting a problem. Wiring Colors – Be Careful!

why wont my trailer lights work?

Many trailer problems are due to a poor grounding connection, which is usually the white wire coming out of the trailer plug. If the ground is poor, lights may work intermittently or not at all. Even if the wiring to the plug is adequate, make sure that the ground connections to the trailer frame are good.

why do my trailer lights work with one vehicle but not another?

Trailer Lights Work On One Vehicle But Not Another. Using a circuit tester like part # 40376, you will want to test each pin on the vehicle connector for function to make sure you are receiving a signal. Check for any corrosion in the harness. Any corrosion can cause problems on a wiring circuit.

does trailer have to be on ball for lights to work?

In some cases trailer lighting will ground through the hitch ball but that’s typically only if the actual ground circuit is insufficient. It needs to ground through the wiring of the trailer harness.

Why are my running lights not working?

Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work. If the issue is not a fuse or relay then you can test the vehicle side trailer connector using a circuit tester such as # 40376. Turn the vehicle headlights on and use the circuit tester to test the pins on the connector at the back.

Are LED trailer lights better?

LED trailer tail lights are brighter, which means other vehicles will see your brake lights better in the daytime. LED units also illuminate faster; when a vehicle’s brake lights are applied, LED lights on the trailer respond instantaneously and provide a brighter, more focused illumination.

Can you replace trailer lights with LED?

This can be fixed by using an LED lamp out bypass adapter. You can also install an LED bulb load resistor on the tow vehicle. One resistor is required for each LED turn signal. If you are converting to LED lights it is also important to replace all of the lights on the trailer with LED’s.

How do you test the ground on a trailer wiring?

Check out the white wire on the trailer to see if it’s actually used as a ground (which it should be). Those 4 wires should be green, yellow,brown and white. Check out the white wire on the trailer to see if it’s actually used as a ground (which it should be).

Why do my trailer lights go out when I hit the brakes?

When trailer lighting does not have a sufficient ground many different scenarios can show up, but the most prevalent is when the most amperage is applied, like tail lights on and brake pedal pressed, the lights go out. All lights must be properly grounded for proper function.

How do you ground a trailer light?

Each lamp needs to be grounded either through its mounting studs being in direct contact with the trailer frame or by having a jumper wire ran from the lamp to the trailer frame. Ground the trailer connector at the front of the trailer, which will use the trailer frame as a ground wire.

Do LED trailer lights need to be grounded?

Yes, all of the lights in the #TL16RK Waterproof, Over 80 inch Trailer Light Kit will need to be grounded. Some trailers will actually end up grounding through the coupler, to the ball of the ball mount, to the hitch, and then to the frame of the tow vehicle.